Grain drying & handling
Don't let the auger be the hold-up.
A dryer or silo is only as quick as the auger feeding it. We size augers to the crop, the distance and the angle so grain doesn't queue, and build them to take a jam instead of breaking in one.
Moving grain
A good auger clears a hold-up instead of becoming one.
Moving grain looks simple until the auger is too short, too slow, in the wrong place or a pain to service. We look at the trailer height, the dryer intake, the silo and the discharge before we tell you what you need, then size the auger to keep up with the dryer, not just to reach the intake.
- 01
Fixed, portable or flexi augers
- 02
Made to length
- 03
For dryer feed and storage
Built tough
Built for the rough work of moving grain.
Replaceable wearing ends
The ends wear first by design, so you swap them out instead of replacing the whole auger.
Slip-clutch drive
The V-belts are set to slip if it jams, so a blockage doesn't wreck the drive.
Emergency hatch
If it ever does block, a hatch drops the material on the spot so you clear it fast.
Easy to service
Bearings, drives and guards laid out so you can inspect and maintain it without a fight.
Gallery
Augers and handling routes
Grain movement equipment connected to dryers and storage areas.
01
02
03010203Common questions
Questions worth settling before you buy.
Yes. We normally start with the crop, volume, site layout, fuel or power source, existing buildings and what is slowing the season down.
Included with every system
Support comes with the system.
Farm visit and sizing
We look at crop, site, fuel, power, buildings and workflow before sizing the system.
Build check-ins
We supply the drawings and check the build at key stages while your builder handles the brickwork.
Season support
Calls, setup help, troubleshooting and practical advice are part of the system.
Related equipment
Often part of the same job.
Talk to ROC Systems
Sort out the hold-up in your grain handling.
Tell us the route, the height, the distance and how much grain you need to move, and we will size the auger.